009 Peco Track Power Advice
Posted: Sun Feb 26, 2023 9:23 am
Hello all,
I hope someone can give me some directions on powering the attached layout with planned sidings. Its been built with 009 Peco Flexi and electrofrog points. Im intending to Power with guagemaster Model D controller. Currently the loop of track is powered however if i change a point I immediatly lose power until the loop is restored. I expect this is down to the electrofrog points. If someone could advise where i need to make changes to rectify it would be much appreciated. Ive drilled holes ready for powered point motors but until the engine can enter a siding i dont want to progress further.
Many Thanks
I hope someone can give me some directions on powering the attached layout with planned sidings. Its been built with 009 Peco Flexi and electrofrog points. Im intending to Power with guagemaster Model D controller. Currently the loop of track is powered however if i change a point I immediatly lose power until the loop is restored. I expect this is down to the electrofrog points. If someone could advise where i need to make changes to rectify it would be much appreciated. Ive drilled holes ready for powered point motors but until the engine can enter a siding i dont want to progress further.
Many Thanks