Hi I have a question about using the Ecos standard detection module on 3 rail with routes. I have set up Lay-out plan on the Ecos with all turn outs functioning through servo modules. Also have wired the detection module so can run shuttle between end stations. Have also prepared routes for different trains which I can manually engage by pressing the route symbol on the Lay-out plan on Ecos. I wanted to know can u automatically trigger a route by either entering or exiting a detection section on Ecos. I have tried to Programme it using the Ecos route function and linking the detection section to the route but doesn’t seem to work?? Any tips or ideas ?
Post all your DCC only problems, solutions and discoverys here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests