Post all your DCC only problems, solutions and discoverys here.
7 posts • Page 1 of 1
Yes, but I seem to remember they need a decoder which is designed to run coreless motors. I seem to remember in the Lenz 2001 DCC lists that they had a specific decoder for those motors. It wasn't cheap,but back then nothing DCC was!
Seconded. All the specialist DCC makers current branded decoders should do the job, a pre-read of manufacturer documentation advisable. This is I would suggest 'no cheaping out' territory (personally I would choose Zimo because their documentation is very specific for optimising set up for coreless motors).
Who is online
Users browsing this forum: No registered users and 1 guest