Hornby TTS Sound, any good?

Post all your DCC only problems, solutions and discoverys here.
Paul-H
Posts: 52
Joined: Fri Jun 05, 2009 3:00 pm

Hornby TTS Sound, any good?

Postby Paul-H » Tue Nov 07, 2017 6:45 pm

Hi all

I am returning to model rail after a few years layup and would like to get back into sound equipped Locos

My only experience is with ESU Loksound decoders which where expensive then and even more so now, however I notice the Hornby do a digital sound system in their TTS decoders, which are a fraction of the cost of Loksound decoders.

What are the views of this system, any good, not worth it, what are they like, any short comings or drawbacks.

Thanks for any input on this.

Paul
Last edited by Paul-H on Wed Jan 10, 2018 7:56 am, edited 1 time in total.

User avatar
TimberSurf
Posts: 1504
Joined: Wed Jan 08, 2014 5:47 pm
Location: N.Wales
Contact:

Re: Hornby TTS Sound, any good?

Postby TimberSurf » Tue Nov 07, 2017 9:02 pm

I have limited experience, but have done a lot of research. (I own 1 SH bachman and 5 x TTS)
Non TTS are blown with specific files to that engine, they have a multitude of additional 'function button' sounds but also other ones that play automatically. TTS cannot be blown with different sounds. TTS have very few 'function button' sounds and they are all manual. TTS have very few CV's you can muck about with. The most annoying being you cannot 'synchronise' the chuff rate with the wheels! (it also doesn't follow the speed linearly).

TTS is very basic, has no flexibility, no chance to modify, but works out the box for very little money.
Non TTS cost a lot more, do a lot more and are open to programming/modification (also work out of the box if factory fitted with loco)

You pays yer money and you takes your choice! It's down to what you want, just sound on the layout or the ability to get advanced features and customisation.
Image
Lumsdonia <--- Hit link to go to my website for full story and wiring advice!

George Stein
Posts: 145
Joined: Sat Jan 07, 2012 3:47 am

Re: Hornby TTS Sound, any good?

Postby George Stein » Wed Nov 08, 2017 11:19 pm

Having looked at this on a number of blogs, I agree completely with the previous comment. I also lament the generally higher cost of DCC sound in the UK compared to here in the USA. HOWEVER, I note that the November 2017 issue of Hornby magazine carries an advert for the Soundtraxx "Econami" line of UK DCC sound decoders. Having used these, I'm quite pleased with them. Significantly less costly. see. page 156. I believe Gaugemaster is the UK distributor.

George
North Carolina

BananaRepublic
Posts: 102
Joined: Thu Nov 04, 2010 7:03 pm

Re: Hornby TTS Sound, any good?

Postby BananaRepublic » Thu Nov 09, 2017 10:53 am

Some (possibly all) of the TTS decoders are proving to have problems working with various DCC systems.
There are lots of reports of people having difficulty with these decoders.
Hornby are supposed to be working on a solution to the problem.



User avatar
RAFHAAA96
Posts: 395
Joined: Tue Feb 19, 2008 1:39 pm
Location: Cyprus

Re: Hornby TTS Sound, any good?

Postby RAFHAAA96 » Thu Nov 09, 2017 1:25 pm

The TTS problems are fully resolved apparently, but its a matter of time to get these fixes to the user as it means returning the decoder/loco to Hornby to reprogram the PIC code of any affected decoders

Hornby posted a statement on their DCC forum essentially asking folk having problems with TTS vs other controllers to contact them for the way ahead towards getting them fixed

I understand that Hornby is now proof testing their decoders with a wide variety of other make controllers. I don't suppose that extra effort is reciprocal by the other manufacturers. Well done Hornby for going above and beyond to ensure their decoders work with other makers kit.

Rob
RAF Halton Brat - 96th Entry
http://www.halton96th.co.uk

BananaRepublic
Posts: 102
Joined: Thu Nov 04, 2010 7:03 pm

Re: Hornby TTS Sound, any good?

Postby BananaRepublic » Sat Nov 11, 2017 9:28 pm

RAFHAAA96 wrote:.......Well done Hornby for going above and beyond to ensure their decoders work with other makers kit.


I wouldn't say they've gone "above and beyond" at all.
Decoders should comply with the DCC standards and work with any system that is properly DCC compliant.



User avatar
RAFHAAA96
Posts: 395
Joined: Tue Feb 19, 2008 1:39 pm
Location: Cyprus

Re: Hornby TTS Sound, any good?

Postby RAFHAAA96 » Mon Nov 13, 2017 8:47 am

BananaRepublic wrote:
RAFHAAA96 wrote:.......Well done Hornby for going above and beyond to ensure their decoders work with other makers kit.


I wouldn't say they've gone "above and beyond" at all.
Decoders should comply with the DCC standards and work with any system that is properly DCC compliant.


Which other manufacturers have a selection of other makers kit to aid their R&D I wonder.

NMRA standards are a bit like NATO standards - everyone makes their bits to their version of the common standard and sometimes these bits don't play nice together. Been there, done that, got the Tee shirt, on a cold, wet foreign airfield cursing the various committees that approved the 'standard matching' parts that didn't.
Rob
RAF Halton Brat - 96th Entry
http://www.halton96th.co.uk

Sammo
Posts: 61
Joined: Fri Apr 10, 2009 9:58 pm

Re: Hornby TTS Sound, any good?

Postby Sammo » Tue Jan 09, 2018 11:41 pm

I use Digitrax
I have 3 TTS sound locos
All work very well but the best one is KING GEORGE
It is very. Good

HOWEVER Out of the box. Has to be the Bachmman.
The other is a Bachmann with ESU sound decoder with Olivia sound.

All locos have tenders.
I dont have any locos with sound other than these.

Biut in main
answer to your question
I am really happy with all of them.

Sammo
Posts: 61
Joined: Fri Apr 10, 2009 9:58 pm

Re: Hornby TTS Sound, any good?

Postby Sammo » Tue Jan 09, 2018 11:44 pm

Forgot to mention
I only run Steam so cannot comment on Diesels.


Return to “DCC Forum”

Who is online

Users browsing this forum: No registered users and 5 guests