Engine shed track distances

Any questions about designing a model railway layout or problems with track work.
BobDM
Posts: 36
Joined: Wed Nov 15, 2017 4:41 pm
Location: Carrick

Engine shed track distances

Postby BobDM » Tue Apr 02, 2019 2:35 pm

Is the space between tracks in front of a steam engine shed the same as on the main line?

I was looking at a picture and I got the impression it was wider, which makes sense considering all the activity around the shed.

Any info gratefully received. Again. I don't know what I would do without this forum.

Bob

User avatar
Bufferstop
Posts: 11336
Joined: Thu Mar 11, 2010 12:06 pm
Location: Bottom end of N. Warks line

Re: Engine shed track distances

Postby Bufferstop » Tue Apr 02, 2019 4:06 pm

Where there are more than two tracks side by side there's usually a 10ft gap to provide safety for personnel who need to be on the track. I've always assumed that the tracks in a shed would be at least 10ft apart. Any one got a tape measure?
Growing old, can't avoid it. Growing up, forget it!
My Layout, My Workbench Blog and My Opinions

User avatar
TimberSurf
Posts: 2427
Joined: Wed Jan 08, 2014 5:47 pm
Location: N.Wales
Contact:

Re: Engine shed track distances

Postby TimberSurf » Tue Apr 02, 2019 4:49 pm

Ultimately it will boil down to how wide the doors on your model shed are!
Image
Lumsdonia <--- Hit link to go to my website for full story and wiring advice!

Ex-Pat
Posts: 1704
Joined: Tue Feb 08, 2011 10:51 pm
Location: Dundalk Ireland

Re: Engine shed track distances

Postby Ex-Pat » Tue Apr 02, 2019 6:05 pm

The 2 roads that go through Hawick shed were real-life 12ft between centres - leaving me approx. 16mm between sleeper ends in model form.

Rather interestingly however there were plans at one stage (that were never implemented) to build a new 3-road shed nearer the turntable. Strangely, the 3 roads would not have been equal distances apart, with 15ft and 21ft between centres!

So you'll be safe going with any of the above unless you have a specific prototype in mind.

User avatar
stuartp
Posts: 1064
Joined: Sat Feb 28, 2009 7:40 pm

Re: Engine shed track distances

Postby stuartp » Wed Apr 03, 2019 1:18 pm

If you have an end-on photo of the shed in question you can work out the distance by comparing with the track. Remember though if working in OO that the rails should be about 19mm apart, not about 17mm !

If not, ten foot minumum is a reasonable assumption, plus a bit if there are structures between the tracks e.g. water crane, bit of timber/girder/wall holding the roof up etc.
Portwilliam - Southwest Scotland in the 1960s, in OO - http://stuart1968.wordpress.com/


Return to “Track/Layout Design”

Who is online

Users browsing this forum: No registered users and 2 guests