New Railway Modellers Forums

I am very new to dcc, having used dc up to now and it is a bit difficult at the moment so I hope someone will be kind enough to try and help me please? The layout I bought included a Hornby Select R8213 at Firmware 1.0 and I have been able to change the loco. addresses, turn lights on and run the lo...

I did find out that Grafar have taken down their service information. My dilemma is that there is no name on the loco that I have in bits but maybe a generic set of instructions would help.
Cheers,
Roy

Thank you for that contact.
I do hope to be able to sort some of my problems myself and with luck I may get practical suggestions from members which will save money.
Cheers,
Roy

I had problems trying to get into one loco and ended up taking out all the screws so now it is in bits! Could someone help so that I don't make the same mistake again please. I will try to attach photos of the loco I am now trying to service/repair. It is a Grafar 2 6 2 GWR and the motor turns but n...

Thanks for all the help. I have found the axle gear wheel is not attached on one loco where the motor runs - but I wrongly dismantled the complete loco so now have the problem of trying to get it all back together - is there an easy way? I will look at the rest but wonder if the bodies of n gauge sh...

Thank you for such a quick and informative reply. I will do some work tomorrow and get back.

Hello Forum members and I hope that someone will be kind enough to give me some advice please? I have just bought an old layout with pretty basic track but loads of good buildings etc. It has an outer loop with access to the inner loop which has some sidings and runs on dc with a twin controller (wi...