Hi
The pva had been left for several weeks and I only had 2mm depth of the liquid.
I have pulled it out in one strip and I did notice the paper layer on the foam board was damp so I suspect the seal from the pva was not sufficient.
I still dont know why it cracked.....
Search found 5 matches
- Wed Jan 23, 2019 7:21 pm
- Forum: General Model Railway Discussion / News
- Topic: Aqua Magic
- Replies: 4
- Views: 565
- Wed Jan 23, 2019 3:56 pm
- Forum: General Model Railway Discussion / News
- Topic: Aqua Magic
- Replies: 4
- Views: 565
Aqua Magic
Hi All
Advice please on using Aqua Magic
I added the liquid to a canal on my layout, which I had sealed with pva and painted the base green.After 25 hours the Aqua Magic had cracked in several places. Any ideas why it has happened would be appreciated. Thanks
Advice please on using Aqua Magic
I added the liquid to a canal on my layout, which I had sealed with pva and painted the base green.After 25 hours the Aqua Magic had cracked in several places. Any ideas why it has happened would be appreciated. Thanks
- Thu Oct 18, 2018 8:46 am
- Forum: Electronics
- Topic: LED Lighting
- Replies: 2
- Views: 583
LED Lighting
Hi I have purchased a set of ten led lamp posts from Ebay They have been supplied with a resistor for each lamp The supplier recommends a supply voltage of 12volts at 20Ma Can someone be good enough to let me know what ampage the transformer should have as an output? I am guessing it should be 200Ma...
- Fri Sep 28, 2018 3:29 pm
- Forum: General Model Railway Discussion / News
- Topic: Dapol motorised signal and Peco Switch
- Replies: 8
- Views: 833
Re: Dapol motorised signal and Peco Switch
Thanks
I have only showed the
housing for the switch as this has the three holes for the wires
I do have the switch that fits into it
So I assume the red and black wires go in the outer two holes and the two
yellow wires go in the centre hole?
I have only showed the
housing for the switch as this has the three holes for the wires
I do have the switch that fits into it
So I assume the red and black wires go in the outer two holes and the two
yellow wires go in the centre hole?
- Fri Sep 28, 2018 11:56 am
- Forum: General Model Railway Discussion / News
- Topic: Dapol motorised signal and Peco Switch
- Replies: 8
- Views: 833
Dapol motorised signal and Peco Switch
pl-51-peco-turnout-points-switch-module-add-on-unit-7065-p.jpg Could anyone advise me on the correct wiring between a dapol signal and a Peco passing contact lever switch which has been fitted into a module with three outputs please? The signal has four wires, two yellow which are the switch wires ...